Configuring The Rs-232 Port And The Ac Receptacle - Extron electronics IPL T PC1 User Manual

• Daylight Savings
in some countries. You can select one of the radio buttons to set the PC1 for daylight
savings time for the U. S., Europe, or Brazil; or select
The following daylight savings periods are observed:
U. S. — Starts the second Sunday in March and ends the first Sunday in November.
•
(Daylight saving time should be turned off in Hawaii, American Samoa, most
equatorial regions, Guam, Puerto Rico, the U. S. Virgin Islands, eastern time zone
portion of the state of Indiana, and the state of Arizona (excluding the Navajo
Nation).
Europe — Starts the last Sunday in March and ends the last Sunday in October.
•
(Daylight saving time should be turned off in Iceland.)
Brazil — Starts the first Sunday in October and ends the third Sunday in February.
•
(Daylight saving time should be turned off in equatorial Brazil.)
3.
When you have made all the desired changes in the Date/Time Settings section, click
the
Submit
displayed in the fields in which you entered them.
If you want to discard your new entries without submitting them and restore the
previous settings, click

Configuring the RS-232 Port and the AC Receptacle

The Port & AC Settings screen, accessed from the Configuration screen, enables you to
specify settings for the RS-232 port and the rear panel AC receptacle.
Figure 19.
Contact input port
This field shows the status of the contact input port. If
(connected to ground). If
NOTE:
: Daylight savings time (DST) is a one-hour offset that is observed
button at the bottom of the section. The new date and time settings are
(do not click
Cancel
Port & AC Settings Page
Off is selected, the contact is open (not connected to ground).
You cannot make changes in this field; it only reflects the condition of the port.
to disable it.
Off
).
Submit
is selected, the contact is closed
On
IPL T PC1 • HTML Configuration and Control 26