Table of Contents
Advertisement
Set IP Address submenu
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric sub-fields (called "octets") that
are separated by periods. Each octet can be numbered from 000 through 255 (leading zeros
are inserted by the DVS). The factory-installed default address is
this conflicts with other equipment at your installation, you can change the IP address to any
valid value via the Set IP Address screen.
To change the unit IP address:
1.
2.
3.
Set Subnet Mask submenu
The subnet mask is used to determine whether the DVS is on the same subnet as the mail
server when you are using a subnet (see
mask address has the same validity rules as the IP address. The default subnet mask is
255.255.000.000
To change the subnet mask:
1.
2.
3.
Set Gateway Addr submenu
The gateway address identifies the gateway to the mail server that will be used if the
scaler and the mail server are not on the same subnet. The default gateway address is
000.000.000.000
To change the gateway address:
1.
2.
3.
NOTE:
Exiting the Menu System
To exit the menu system, press the Menu button repeatedly until the
NEXT
Alternatively, wait until the menu system times out and the default cycle resumes
(approximately 30 seconds).
Picture Controls
The DVS has six picture control buttons located on the front panel to the right of the PIP
buttons. You can use these buttons to adjust size, position, brightness and contrast, color
and tint, detail, magnification (zoom), and select a portion of the image on which to
focus the view (pan). (See the
explanation of these button functions.)
NOTE:
Press Next until the Set IP Address screen is displayed.
Rotate the horizontal Adjust knob ({) to select an octet. (The selected octet flashes.)
Rotate the vertical Adjust knob ([) to increase or decrease the flashing number.
.
Press Next until the Set Subnet Mask screen is displayed.
Rotate the horizontal Adjust knob ({) to change the flashing octet selection.
Rotate the vertical Adjust knob ([) to increase or decrease the flashing number.
.
Press Next until the Set Gateway Addr screen is displayed.
Rotate the horizontal Adjust knob ({) to change the flashing octet selection.
Rotate the vertical Adjust knob ([) to increase or decrease the flashing number.
The Edit Comm Settings menu has no MAC address screen, because the MAC
address cannot be changed.
screen appears. Press the Next button to return to the default cycle.
Picture Controls Summary
When PIP mode is active, all these picture controls apply to the PIP window. To
configure the main window, press the PIP On/Off button to exit PIP mode.
192.168.254.254
"Subnetting, a
Primer" on page 120). The subnet
table on the next page for an
DVS 510 Series • Operation
, but if
Exit Menu? Press
36
Advertisement
Table of Contents
