Table of Contents
Advertisement
Figure 172
Bottom view of AXW-MLC
(/PB) connectors and circuit
card removal example
Black/White LCD Mini-Touch Panels
Gently rotate the circuit card backward until you can lay it down flat with the
7.
batteries exposed.
Carefully pry the old battery out of its socket and insert a new battery.
8.
Rotate the circuit card back to the original position inside the wood enclosure
9.
Connect the touch overlay's ribbon cable connector, backlight connector, and 4-
10.
pin AXlink connector to the circuit card.
Connect the mini-XLR connector to the AXW-MLC (/PB) for approximately 1
11.
minute. Then, disconnect the mini-XLR connector.
Disconnect the touch overlay's ribbon cable connector, backlight connector, and
12.
AXlink connector from the circuit card.
Repeat steps 6 through 10 for the second battery. Then, go to step 14.
13.
Insert the four mounting screws into the circuit card and tighten.
14.
Place the bottom panel onto the AXW-MLC (/PB) and insert the six mounting
15.
screws and tighten.
Connect the mini-XLR connector to the AXW-MLC (/PB).
16.
4-pin AXlink connector
4-pin header connector
Backlight connector
Lift circuit card up
and out as shown
Touch overlay
ribbon cable
Replacing the Lithium Batteries
121
Advertisement
Table of Contents
