Input Module Insertion Into The Projector - Barco R9001890 Owner's Manual

Connections

Input module insertion into the projector

To insert a module in one of the free slots, handle as follow :
1 Power down the projector and disconnect the power cord from the wall outlet.
2 Remove the dummy plate covering the chosen input slot by turning out both screws.
3 Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4 Press on both handles of the input module until the module plug seats in the connector of the projector.
5 Secure the input module by tightening both retaining screws.
6 Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
2Q
4-4
9 vht‚†‡vpÃ8 ‚qr
B…rrÃP ƒr…h‡v‚
S rqÃT ‡hqi’
U‚Ðh ’
Ch…qv…rq
uh…qv…rq
…r€ ‚‡r …r€ ‚‡r
8USGÃ!
8US GÃ"
T’pÃP F DS
Ch…qv…rq
…r€ ‚‡r ST!"!#!!ÃP VU
S T!"! #!! ÃDI
8USGÃ

 
P V U DI Ã
 

P
T9DÃ9DB DU6G ÃDIQ VU
C8 W
S B 7
CvtuÃ7hq vq‡uÃÃ$Ã867G@ÃDIQVU
9WDÃDIQVU
C8 W
S B 7
CvtuÃ7hqvq‡uÃÃ$Ã867G@ÃDIQVU
9WDÃDIQVU
DSS rp rv‰r…
8 P HHÃQP SU USDB B@SÃP VU
DI Ã P V U

 
 

5
C9ÃT9DÃ9DBDU6 GÃHP9VG@
9WDÃPVUQVU
5976229 BARCOSLM G5 15032001