Communication Connections; Rs232 Connections; Communication Port For Communication With Peripherals; Trigger Output - Barco R9001890 Owner's Manual

Communication Connections

Available communication connections :
RS232/422 connection between projector and computer.
Communication port for communication with BARCO peripherals.

Trigger output

RS232 Connections

RS 232/422 input and RS232/422 output of the projector.
The projector has a RS232/422 input port that allows it to communicate with a computer.
The RS232/422 output port can be used as loop through to the next device.
Applications
a) remote control :
- easy adjustment of projector via IBM PC (or compatible) or MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
b) data communications :
- sending data to the projector or copying the data from the projector to a hard memory device.
Set up of the Baud Rate for Communication with a Computer.
See 'Change Baudrate PC' in chapter 'Service mode'.

Communication port for communication with peripherals.

Connecting a RCVDS 05 to the projector.
- Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
- The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED on the
rear.
For more information about the use of : the RCVDS 05, consult the owner's manual.
Connecting a VS05 to the projector
The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to
the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier.
Order number : R9827890
For more information about the use of the VS05, consult the VS05 owner's manual.
Connecting an IR Remote Receiver to the projector.
This infrared receiver unit makes it possible to control the projector from another room.
There is a communication line cable between the IR receiver and the projector or the RCVDS. The control information from the RCU
can now be sent to the IR Remote Receiver.
The IR Remote Receiver displays the selected source on a 7-segment display.
Trigger output
5 V output voltage to trigger an external device (max. 10 mA).
This voltage is available when the projector is on.
5976229 BARCOSLM G5 15032001
Connections
4-9