Connections; Power Connection To Projector - Barco R9001890 Owner's Manual

4

CONNECTIONS

Power Connection to Projector

AC Power (mains) cord connection
Use the supplied power cord to connect the projector to the wall outlet. Plug the female power connector into the black male connector
on the side of the projector.
The power input is 230 VAC.
Needed power connection : 7 A.
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Switching ON
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
5976229 BARCOSLM G5 15032001
230V/7A
50/60Hz
Connections
$

(;,7
67$1'%<
 
(17(5
 
7(;7 3$86(
 
6+$531 7,17 %5,*+71
 
3+$6( &2/25 &2175$67
$'- (;,7
( 17(5
67%< 3$86( 7( ;7 )5((=


+( /3
" 3+$6(



6+$531 (66




7,17


 
&2/25


 
%5,* +71(66


 
&2175$67
 D
4-1