Axis 950 User Manual page 62

Appendix C: Updating the Software
Updating the Axis
CD-ROM server
Flash Memory
Caution
62
You can carry out an update to your Flash memory over the network
using FTP on a TCP/IP network.
To upgrade over the network you will need the following:
• The file with the new print server software. The name of this file
is on the form product.version, e.g. 850.210 for the software
release 2.10 for the AXIS 850 CD-ROM server. Retrieve the
updated file from Axis (http://www.axis.se/) or your local
distributor.
• A computer on the network with TCP/IP and a FTP.
• The CD-ROM server must also be installed on the network with
TCP/IP as described in the section 3, Network Configuration.
Follow the steps below to upgrade the print server software:
1. Log in to the Axis CD-ROM server with the command
where
<host name>
your system host table.
2. You will be prompted for user id and password. Use the user id
, which has the default password
root
with the highest priority).
3. Issue the command
4. Issue the command
<software name>
software, e.g.
850.210
5. Wait for the Flash load to finnish. This normally takes 1 to 4
minutes. The unit will then automatically restart with the new
print server software.
Be careful not to interupt the file transer. If the transfer is
interuppted the CD-ROM server may have to be re-initialized by
your dealer.
6. Log out using the command
your FTP version.
Instructions on how to carry out the update are also supplied with the
software update.
is the name assigned in
<host name>
pass
to change to binary transfer mode.
binary
put <software name> flash
is the name of the new CD-ROM server
.
,
quit bye
AXIS 850/950 User's Manual
ftp
( is the user id
root
where
or depending on
exit