Using 3 ½" External Diskette Drive - Toshiba TE2000 User Manual

Using 3 ½" external diskette drive
An optional 3 ½" external diskette drive module connects to the USB
port.
USB CONNECTOR
Eject button
Diskette slot
Disk-In-Use
Indicator
Check the Disk-In-Use indicator when you use the diskette drive. Do not
press the eject button, disconnect a drive cable or turn off the computer
while the light is glowing. Doing so could destroy data and damage the
diskette or the drive.
The external diskette drive should be placed on a flat, horizontal surface
when in use. Do not set the drive on an incline greater than 20
operating.
Do not set anything on top of the diskette drive.
If you need to boot the computer from the diskette drive or if you use an
OS that does not support USB, you must set the USB-FDD Legacy
Emulation feature in HW Setup to Enabled. Refer to the USB section in
Chapter 7.
TOSHIBA TE2000
DISK-IN-USE
INDICATOR
DISKETTE SLOT
The 3 ½" external diskette drive
When a diskette is fully seated in the drive, the
eject button pops out. To remove a diskette,
push in the eject button and the diskette pops
out partially for easy removal.
Insert diskettes in this slot.
This indicator lights when the diskette is being
accessed.
EJECT BUTTON
Operating Basics
o while it is
4-10