Installing The Battery Pack; Starting The Computer By Password - Toshiba TE2000 User Manual

Installing the battery pack

To install a battery pack, follow the steps below.
The battery pack is a lithium ion battery, which can explode if not properly
replaced, used, handled or disposed of. Dispose of the battery as required
by local ordinances or regulations. Use only batteries recommended by
TOSHIBA as replacements.
1. Be sure the computer's power is off and all cables are disconnected.
2. Insert the battery pack.
3. Secure the battery pack lock.

Starting the computer by password

If you registered a password as supervisor or user, you must enter it to
start the computer. For more information about how to set a password,
refer to Chapter 7, HW Setup and Passwords.
To start up the computer with the password, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started and the
following message appears:
S
2. Enter the password.
3. Press Enter. The computer displays the message below while it starts up.
S
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
TOSHIBA TE2000
Installing the battery pack
Password =
Valid password entered, system is now starting up.
Power and Power-Up Modes
6-12