Problem
Character display
becomes garbled
during a
communication
You cannot receive
an incoming call
Hibernation
Problem
Hibernation does
not work
Memory expansion
Refer also to Chapter 8, Optional Devices, for information on installing
memory modules.
Problem
Beep sounds and
computer displays
Please remove
the
incompatible
memory module
in Slot X
(X represents A or B)
TOSHIBA TE2000
Procedure
In data transmission, make sure the parity bit
and stop bit settings correspond with those of
the remote computer.
Check the flow control and communication
protocol.
Check the rings before auto answer setting in
your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Procedure
Are you using a compression utility on C drive?
Hibernation will not work with a compression
utility.
If problems persist, contact your dealer.
Procedure
Make sure the memory module installed in the
expansion slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Disconnect the AC adaptor and all peripheral
devices.
2. Remove the battery pack.
3. Remove the memory module.
4. Replace the battery pack and/or connect the
AC adaptor.
5. Turn on the power.
If problems persist, contact your dealer.
Troubleshooting
9-19