Toshiba TE2000 User Manual page 115

Power on Boot Select
When this option is enabled, you can change the boot drive during start
up. The following message will appear for one or two seconds Press
[F12] for the boot drive selection menu.
To change the boot drive, follow the steps below.
1. Press F12 while the above message is on the screen.
2. The following menu will be displayed:
S
If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
In this computer, CD refers to the DVD-ROM, CD-R/RW or
CD-RW/DVD-ROM drives.
Press the key (C, N, U, 1, 2, P or D) corresponding to the desired device.
The selection method above does not change the boot priority settings in
HW Setup.
If you press a key other than one of those above or if the selected device
is not installed, the system will boot according to the current setting in
HW Setup.
HDD Priority Options
This option lets you set the boot priority for the HDD if more than one is
installed in the computer.
Built-in HDD ->
Second HDD
Second HDD ->
Built-in HDD
TOSHIBA TE2000
Enabled (Default)
Disabled
Select Boot Device
[C]: CD-ROM
[N]: Network (LAN)
[U]: USB Floppy Drive
[1]: Primary Hard Drive (Built-in)
[2]: Secondary Hard Drive (SelectBay)
[P]: PC Card Drive Hard Drive
[D]: Default SYSTEM SETUP Device
Press [C], [N], [U], [1], [2], [P] or [D]
The built-in HDD is checked first for the boot
command, then the HDD installed in the Slim
SelectBay. (Default)
The HDD installed in the Slim SelectBay is
checked first for the boot command, then the
built-in HDD.
HW Setup and Passwords
7-9