When To Use Scsiselect; Starting Scsiselect; Bios Banner - Adaptec AHA-3940 User Manual

AHA-3940/3940W User's Guide

When to Use SCSISelect

Use SCSISelect if you need to
Change any of the default values listed on page 3-3
Check or change SCSI device settings that may conflict with
those of other devices (e.g., SCSI ID)
Perform low-level formatting on new SCSI disk devices

Starting SCSISelect

There are two ways to start SCSISelect:
Press Ctrl+A when the BIOS banner appears during bootup, as
shown in Figure 3-1.
Adaptec AHA-3940/3940W BIOS v1.00
(c) 1994 Adaptec, Inc. All Rights Reserved.
Press <Ctrl><A> for SCSISelect(TM)Utility!
SCSI ID #0 - MAXTOR
SCSI ID #2 - QUANTUM
SCSI ID #3 - Toshiba
SCSI ID #4 - ARCHIVE
BIOS Installed Successfully!
This banner appears when you power up or reboot your com-
puter. The BIOS banner lists the model number and SCSI ID of
each SCSI device connected to the host adapter.
Download the executable version of SCSISelect from the
Adaptec BBS by calling the phone number listed on page ii at
the front of this User's Guide. Then run the program by typing
the file name at the DOS prompt and pressing Enter.
3-4
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-3940/3940W User's Guide
A
A A
Stock Number: 510600-00, Rev. A
A A
A A Print Spec Number: 492707-00
A A
Current Date: 8/24/94
AAAA AAAA A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
P1-17S - Drive C:
P40S-94-40-04xx - Drive D:
CD_ROM:XX3355
VIPER 150 21247
Figure 3-1. BIOS Banner
ECN Date: 08/30/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
(80h)
(81h)
A
A A
A A
Page: 3-4 A A
A
A A
A A
AAAA AAAA AAAA AAAA AAAA A A A A