Equipment Configuration - Bosch APC-AMC2-4W Installation Manual

AMC2 4W
3.2

Equipment Configuration

Fig. 3.3 Upper circuit board with display (top side)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Docking station for the compact flash
Bosch Security Systems
Internal tamper contact
DIL switch for RS-485 address selection, protocol and RS-
232/RS-485 selection
Lithium battery for buffering of static RAM and real time
clock (RTC). The battery shall be replaced by qualified per-
sonnel every ten years or if indicated by an appropriate
event.
Reset push button - available by using the srew driver
LC Display
Push button to select the display view - available by using
the push button on the top of the housing
Jumper: Potential equalization between different mass sys-
tems and protective earth (shield)
Jumper: interface selector RS-485 Host connection, RS-
485 two wire or RS-485 four wire (depends on external
wiring)
Configurable RS-485 host interface (pluggable screw con-
nector)
Installation manual
Introduction | en 15
F.01U.024.965 | V.4 | 2006.09