Safety Precautions - Bosch APC-AMC2-4W Installation Manual

AMC2 4W
2.3

Safety Precautions

Read instructions!
!
Before working with the AMC2 4W, read these instructions
carefully. Make sure you have understood all information
described in this document.
Warning! Risk of electric shock!
!
External power supplies must be installed and put into service
by qualified personnel. Compliance with the relevant regula-
tions must be ensured.
Warning! Risk of damaging equipment!
!
Health and Safety
Installation of the AMC2 4W must comply with any local fire,
health and safety regulations. A secured door that may be part
of an escape route from an area must be installed with:
!
Bosch Security Systems
•
Always switch off power of the AMC2 4W before mod-
ifying the installation.
•
Do not connect or disconnect plug connectors, data
cables or screw connectors while power is on!
•
A fail-safe lock. So that the door will be released if
power fails. Ideally, a magnetic lock should be used as
these are less likely to jam or seize.
•
A normally-closed break-glass or manual pull in the
lock supply wiring, so that in an emergency the fail-
safe lock can be immediately powered down.
Installation manual
Safety Instructions | en 11
F.01U.024.965 | V.4 | 2006.09