Bosch APC-AMC2-4W Installation Manual page 38

38 en | Installing
Fig. 5.15 Location of the Ethernet interface
NOTE!
After the connection of a new AMC in a network using DHCP it
can take several time if the AMC is known on the remote server.
This cause in the DNS cache of the lokal PC - it will be refreshed
i
only after special duration.
To speed up this procedure give in the following command in a
command prompt:
ipconfig /flushdns
After this the AMC should be available by its name.
NOTE!
i
A complete connection diagram of the Ethernet host interface is
shown in Figure 7.4.
F.01U.024.965 | V.4 | 2006.09 Installation manual
AMC2 4W
Bosch Security Systems