Bosch APC-AMC2-4W Installation Manual page 35

AMC2 4W
NOTE!
Using Ethernet connection it is recommended to set switch 1 to
ON (= delivery status)
i
Using RS-232 connection the address must be set, which is con-
figured in the Device Editor. Therefore this is a point-to-point
connection the usually configured address will be 1 - so the
switch 1 must be also set to ON.
Fig. 5.13 Location of the RS-485 address selector
Bosch Security Systems Installation manual
Installing | en 35
F.01U.024.965 | V.4 | 2006.09