Drive Led Cable Option - HP ProLiant ML110 G7 User Manual

Slide the drive cage assembly fully into the server chassis and install the four screws.
10.
Install the drives
11.
CAUTION:
all bays are populated with either a component or a blank.
Install the access panel (on page 21).
12.
Lock the tower bezel.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server (on page 19).
16.

Drive LED cable option

The SAS drive LED cable provides LED functionality for non-hot-plug SAS drives when an optional SAS
controller and an optional SAS controller cable are installed.
To install the component:
Power down the server (on page 19).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the tower bezel
3.
Remove the access panel (on page 21).
4.
Install the optional SAS controller. For more information, see "Expansion boards
5.
options" on page 48)."
Connect the SAS drive LED cable to the system board (pin J40) and to the SAS controller.
6.
Install the access panel (on page 21).
7.
Lock the tower bezel.
8.
("Installing a drive" on page 30).
To prevent improper cooling and thermal damage, do not operate the server unless
("Unlock and open the tower bezel" on page 20).
Hardware options installation 37
("Expansion board