Enabling The Dedicated Ilo Management Port - HP ProLiant ML110 G7 User Manual

Using a flat screwdriver, toggle the knockout to loosen it, and then pull it out of the chassis.
5.
Install the dedicated iLO management module.
6.
Install the access panel (on page 21).
7.
Lock the tower bezel.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server (on page 19).
11.

Enabling the dedicated iLO management port

The onboard NIC 1/shared iLO connector is set as the default system iLO port.
To enable the installed dedicated iLO module:
During the server startup sequence after module installation, to access iLO RBSU, press the F8 key.
1.
Hardware options installation 51