Main Fuse; Checking The Tyre Pressure; Checking The Engine's Cooling Air Intake - Husqvarna Rider 316T Operator's Manual

Hide thumbs Also See for Rider 316T:
Table of Contents

Advertisement

5 Press the lamp in place in the locking bracket
6 Fit the lamp holder in the lower slots on the servo housing.
7 Refit the cables and screw the lamp holder on to the servo
housing.

Main fuse

The main fuse is placed in a detachable holder under the
battery case's cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Maintenance

Checking the tyre pressure

The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Having the same air pressure in the tyres is important in
order to achieve the best possible performance as well as
to avoid damage to the machine
Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
!
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.
– 23
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316t awdRider 316ts awdRider 316txs awd

Table of Contents