Release Lever - Husqvarna Rider 316T Operator's Manual

Release lever

The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Should you attempt to drive the machine with the clutch
controls pulled out it will not move. The drive on the axle is
disengaged when one of the controls is pulled out.
Pull the controls to the end positions, do not use an
intermediate position.
Clutch control Rider 316T AWD, 316TXs
AWD and Rider 316Ts AWD
Rider 316T AWD, 316TXs AWD and Rider 316Ts AWD have
one control for the front axle and one control for the rear axle.
IMPORTANT!
Always drive the machine with both clutch controls pressed
in.
• Clutch control, rear axle
- Control drawn out, drive system disengaged.
- Control depressed, drive system engaged.
• Clutch control, front axle
The control is positioned on the inside of the left front
wheel.
- Rear control (pulled out), drive system disengaged.
- Front control (pushed in), drive system engaged.
14 –
English
PRESENTATION
Release lever Rider 316T
• Pull out the control to disengage the drive system.
Push in the control to engage to the drive system.