Maintenance; Maintenance Schedule - Husqvarna Rider 316T Operator's Manual

Hide thumbs Also See for Rider 316T:
Table of Contents

Advertisement

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.

Maintenance

Cleaning
Check the engine's oil level
Check the engine's cooling air intake
Check the fuel pump air filter
Check the steering wires
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage.
Clean around the silencer
Clean the prefilter in the air filter
3, 4)
Change the engine oil
Check the cutting deck
Check the air pressure in the tyres, 60 kPa/8.5 PSI.
Lubricate the belt adjuster
Lubricate joints and shafts
Adjust the brake
Check the V-belts
Check the cooling fins on the hydrostatic transmission
Checking the transmission oil level
Checking and adjusting the choke wire
Tighten the nuts and screws
Checking and adjusting of throttle wire
Clean the cooling fins on the engine and hydrostatic transmission
Replace the air filter's prefilter and paper filter
Replace the fuel filter
Replace the spark plug.
Check the engine valve clearance
Check the need to change the oil
Change the oil filter
Clean the combustion chamber
Decarburization and valve grinding
Check the synchronisation between the front and rear wheels.
Check the fuel hose. Replace if necessary .
1)
If the machine is used daily it should be lubricated twice a week.
hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
6)
annually or every 200 hours.
Conducted by authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be conducted
!
on the engine or cutting unit unless:
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
The ignition cables are removed from the plugs.
18 –
English
Maintenance
2)
1)
1)
2, 5)
6)
6,7)
in the gearbox/hydraulic system
6)
6)
6)
2)
Maintenance and replacement are required more often in dusty conditions.
Daily maintenance
before starting
X
X
X
X
X
X
X
O
O
O
X
2)
4)
Replace the oil filter every 200 hours.
7)
Only 316T AWD, 316Ts AWD, 316TXs AWD first change after 8 hours
At least
Maintenance
once a year
interval in hours
25
50
100 200
X
3
X
X
X
X
X
X
X
O
O
X
O
X
O
X
X
X
O
O
O
3)
First change after 8
5)
Replace the paper filter
3
X
O
X

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316t awdRider 316ts awdRider 316txs awd

Table of Contents