Checking And Adjusting The Choke Wire; Replacement Of Fuel Filter; Checking The Fuel Pump's Air Filter; Replacing The Air Filter - Husqvarna Rider 316T Operator's Manual

Hide thumbs Also See for Rider 316T:
Table of Contents

Advertisement

Checking and adjusting the choke
wire
If the engine is producing black smoke or is difficult to start
then the choke wire (upper wire) may be incorrectly adjusted.
If doubts arise, contact your service representative.
If it is necessary to adjust the choke, proceed as follows:
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Check that the throttle wire is attached to the upper lever,
see diagram.
3 Pull the choke wire casing to the far right and tighten the
clamping screw.
Replacement of fuel filter
Replace the fuel filter every 100 running hours (once per
season) or more frequently if it is clogged.
Replace the filter as follows:
1 Open the engine cover.
2 Move the hose clips away from the filter. Use a pair of flat
pliers.
3 Pull off the filter from the hose ends.
4 Press the new filter into the ends of the hoses. If
necessary apply liquid detergent to the ends of the filter to
facilitate connection.
5 Push the hose clips back on the filter and tighten.
Checking the fuel pump's air filter
Check regularly that the fuel pump's air filter is free from dirt.
The filter can when necessary be cleaned with a brush.
Maintenance
Replacing the air filter
!
If the engine seems to lack power or does not run smoothly
this may be because the air filter is clogged. It is therefore
important to replace the air filter at regular intervals (see
Maintenance/Maintenance Schedule for the correct service
interval).
Replace the air filter as follows:
1 Loosen the knobs holding the filter cover in place and
remove it.
2 Loosen the hose clip that holds the filter cartridge.
3 Remove the filter cartridge from the filter housing.
IMPORTANT INFORMATION
Never run the engine without the air filter fitted.
The filters must not be oiled. They must be fitted dry.
4 Remove the foam rubber prefilter which is placed around
the filter cartridge and clean using a mild detergent.
5 Dry the pre-filter properly.
6 Clean the filter by knocking it with care against a hard
surface. Do not use compressed air to clean the filter.
Replace the air filter if it is still dirty.
Always replace the paper filter every 200 hours.
7 Refit the pre-filter on the paper filter.
WARNING! The exhaust system is hot. Let it
cool before starting to replace the air filter.
– 21
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316t awdRider 316ts awdRider 316txs awd

Table of Contents