Lights And Power Outlet; Release Lever - Husqvarna PR 17 Operator's Manual

Lights and power outlet

PR 17 and PR 17 AWD
2 3
1
PF 21 and PF 21 AWD
2
3
1
The lights are switched on and off using the power switch (1)
on the control panel.
A seat heater or mobile phone charger are examples of
articles that can be connected to the power socket (2).
The power outlet is switched on and off using power switch (3)
on the control panel.
The voltage is 12 V.
The power outlet is fuse protected by its own fuse, which is
located below the ignition switch.

Release lever

The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Should you attempt to drive the machine with the clutch
controls pulled out it will not move. The drive on the axle is
disengaged when one of the controls is pulled out.
Pull the controls to the end positions, do not use an
intermediate position.
Clutch control PR 17 AWD and PF 21 AWD
PR 17 AWD and PF 21 AWD have one control for the front
axle and one control for the rear axle.
IMPORTANT! Always drive the machine with both clutch
controls pressed in.
• Clutch control, rear axle
- Control drawn out, drive system disengaged.
16 –
English
PRESENTATION
- Control depressed, drive system engaged.
• Clutch control, front axle
The control is positioned on the inside of the left front
wheel.
- Rear control (pulled out), drive system disengaged.
- Front control (pushed in), drive system engaged.
Clutch control PR 17 and PF 21
• Pull out the control to disengage the drive system.
• Push in the control to engage to the drive system.