Bridge Mode - D-Link DSL-G604T User Manual

DSL-G604T Generation II ADSL2+ Wireless Modem Router

Bridge Mode

The WAN Settings window is also used to configure the Router for multiple virtual connections (Multiple PVCs).
WAN Settings window – Bridge Mode
Select the connection type used for your account. The window will display settings that are appropriate for the
connection type you select. Follow the instruction below according to the type of connection you select in the
WAN Settings window.
For Bridged connections it will be necessary for most users to install additional software on any computer that
will the Router for Internet access. The additional software is used for the purpose of identifying and verifying
your account, and then granting Internet access to the computer requesting the connection. The connection
software requires the user to enter the User Name and Password for the ISP account. This information is stored
on the computer, not in the Router.
Follow the instructions below to configure a Bridged connection for the WAN interface.
To configure a Dynamic IP Address connection, perform the steps listed below. Some of the settings do not
need to be changed the first time the device is set up, but can be changed later if you choose. See the table
below for a description of all the settings available in this window.
Page 43 of 110 www.dlink.com.au