Static Routing - D-Link DSL-G604T User Manual

DSL-G604T Generation II ADSL2+ Wireless Modem Router

Static Routing

Use Static Routing to specify a route used for data traffic within your Ethernet LAN or to route data on the
WAN. This is used to specify that all packets destined for a particular network or subnet use a predetermined
gateway.
Routing Table window
To add a static route to a specific destination IP on the local network, enter a Destination IP address,
Netmask, then click the Gateway radio button and type in the Gateway's IP address. Click Apply to enter the
new static route in the table below. The route becomes active immediately upon creation.
To add a static route to a specific destination IP on the WAN, click the Connection radio button and choose a
connection from the pull-down menu, then enter a Destination IP address and Netmask. Click Apply to enter
the new static route in the table below. The route becomes active immediately upon creation
To remove a static route from the table in the bottom half of the window, choose to Delete it from the table and
click the Apply button. Remember to save the configuration changes.
Page 66 of 110 www.dlink.com.au