Information You Will Need About Your Lan Or Computer - D-Link DSL-G604T User Manual

Information you will need about your DSL-G604T ADSL 2+ Router:
Username
Password
LAN IP addresses for
the DSL-G604T
LAN Subnet Mask for
the DSL-G604T

Information you will need about your LAN or computer:

Ethernet NIC
DHCP Client status
It is recommended that your collect and record this information here, or in some other secure place, in case
you have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-G604T ADSL 2+ Router.
Page 7 of 110
DSL-G604T Generation II ADSL2+ Wireless Modem Router
This is the Username needed access the Router's management
interface. When you attempt to connect to the device through
a web browser you will be prompted to enter this Username.
The default Username for the Router is "admin." The user
cannot change this.
This is the Password you will be prompted to enter when you
access the Router's management interface. The default
Password is "admin." The user may change this.
This is the IP address you will enter into the Address field of
your web browser to access the Router's configuration
graphical user interface (GUI) using a web browser. The
default IP address is 10.1.1.1. This may be changed to suit
any IP address scheme the user desires. This address will be
the base IP address used for DHCP service on the LAN when
DHCP is enabled.
This is the subnet mask used by the DSL-G604T, and will be
used throughout your LAN. The default subnet mask is
255.255.255.0. This can be changed later.
If your computer has an Ethernet NIC, you can connect the
DSL-G604T to this Ethernet port using an Ethernet cable. You
can also use the Ethernet ports on the DSL-G604T to connect
to other computer or Ethernet devices.
Your DSL-G604T ADSL 2+ Router is configured, by default, to
be a DHCP server. This means that it can assign an IP address,
subnet mask, and a default gateway address to computers on
your LAN. The default range of IP addresses the DSL-G604T
will assign are from 10.1.1.2 to 10.1.1.254. Your computer
(or computers) needs to be configured to Obtain an IP
address automatically (that is, they need to be configured
as DHCP clients.)
Record info here
Record info here
www.dlink.com.au