Gsw-1600S/2400S Rear Panel; Installing Agsw-1600S/2400S; Desktop Installation - Planet GSW-1600S User Manual

2.1.4 Switch Rear Panel
The rear panel of the Switch indicates an AC inlet power socket, which accepts input power from 100 to 240VAC,
50-60Hz.
@ To press and release the RESET button, the Switch will back to the factory default mode. Be sure that
Note
:
you'd backup the current configuration of the Switch otherwise the entire configuration will be erased
when pressing the "RESET" button.
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your switch from being damaged by
unregulated surge or current to the Switch or the power adapter.
2.2 Installing the Switch
This section describes how to install your GSW-1600S/2400S Web Smart Gigabit Ethernet Switch and make connections
to the Switch. Please read the following topics and perform the procedures in the order being presented. PLANET Web
Smart Gigabit Ethernet Switch do not need software configuration. To install the Switch on a desktop or shelf, simply
complete the following steps.

2.2.1 Desktop Installation

To install a Switch on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the switch.
Step2: Place the Switch on a desktop or shelf near an AC power source.
Step3: Keep enough ventilation space between the switch and the surrounding objects.
@ When choosing a location, please keep in mind the environ mental restrictions discussed in Chapter
Note
:
1, Section 4, in Specification.
Step4: Connect your Switch to network devices.
A. Connect one end of a standard network cable to the 10/100/1000 RJ-45 ports on the front of the Switch
B. Connect the other end of the cable to the network devices such as printer servers, workstations or routers ...etc.
@
Connection to the Switch requires UTP Category 5 network cabling with RJ-45 tips. For more
Note
:
information, please see the Cabling Specification in Appendix A.
Step5: Supply power to the Switch.
A. Connect one end of the power cable to the SWITCH.
RESET
Figure 2-3 GSW-1600S Rear Panel
RESET
Figure 2-4 GSW-2400S Rear Panel
100~240V AC
ON
50 /60 Hz OFF
Power
100~240V AC
ON
50 /60 Hz OFF
Power
4