Press the port ID to configure each port 's speed, flow control, QoS priority and link status. The screen in Figure 3-23
appears.
The options and descriptions of Port Settings show as below:
Speed: this function provides six modes —100M Full, 100M Half, 10M Full, 10M Half, Auto and Disable
Flow Control: this setting determines whether or not the Switch will be handling flow control. Set Flow Control to enable for
avoiding data transfer overflow. Or it sets to disable; there is either no flow control or other hardware/software
management. When the port is set to forced mode, then the flow control will automatically set to disable.
QoS: In some ports that need to have a high priority to deal with the data transfer, QoS should be change. The default
setting of all port QoS is Normal, set the QoS to High where the
@
When set each port to run at 100M Full, 100M Half, 10M Full, and 10M Half-speed modes. The
Note
:
Auto-MDIX function will disable.
Figure 3-22 The Port Setting page
Figure 3-23 The Per Port Setting page
ports have a high priority of transferring data.
19