Planet GSW-1600S User Manual page 19

@ In order to receive Trap information, the Trap IP and Trap Events must be configured in the GSW
Note
:
-1600S /2400S Web management interface. Please refer to chapter 3.1.2.10 Trap for detail
information.
Add Item: To add a device to the Monitor List manually, enter the IP Address of the device that want to monitor.
Delete Item: To delete the device from the Monitor List.
3.1.1.4 Device Settings
This function contains four items to configure the Switch
Configuration Setting: this function is to assign IP Address, Subnet Mask, Gateway and Set Trap to (Trap IP Address),
System name and Location. Select one device in the Discovery list or Monitor List and press this button, then the
Configuration Setting message window pops up as Figure 3-17, after filling up the data that need to change and fill up the
password, press the "Set" button to take effect.
Password Change: this function is to change password. Fill in the password needed in the dialog box and press "Set"
button to take effect. The screen in Figure 3-18 appears.
Firmware Upgrade: this function is to upgrade firmware of Switch. The screen in Figure 3-19 appears.
Figure 3-16 Trap information
.
Figure 3-17 Configuration setting
Figure 3-18 Password Change
16