Configure The Gsw-1600S/2400S - Planet GSW-1600S User Manual

Figure 3-19 Firmware Upgrade
Web Access: Double click the device in the Monitor List or select a device in the Monitor List and press this "Web
Access" button to access the Web interface of Switch.
3.1.2 Configure the Switch
The Switch Web Smart Gigabit Ethernet Switch provide Web interface for Switch smart function configuration. The
GSW-1600S /2400S can be configured through the Web Browser. A network administrator can manage and monitor the
GSW-1600S /2400S from the local LAN. This section indicates how to configure the Switch to enable its smart function.
The smart functions are shown as below:
◆ Port Setting (Speed/Disable, Duplex mode, Flow Control and Port base QoS)
◆ Virtual LAN Group setting (VLAN)
◆ Trunking
◆ Port Mirroring
◆ System Setting
◆ Device status and Statistic
◆ Trap and Password
◆ Backup Setting
3.1.2.1 Login the Switch
Before you start configure the Switch, please note the Switch is configured through an Ethernet connection, make sure the
manager PC must be set on same the IP subnet address. For example, the default IP address of the Switch is
192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default
subnet mask is 255.255.255.0. Use Internet Explorer 5.0 or above Web browser. Enter IP address http://192.168.0.1 (the
factory-default IP address) to access the Web interface.
Or through the Web Switch Utility, do not need to remember the IP Address, select the device in the Monitor List of the Web
Switch Utility to settle the device through the Web Browser. When the following login screen appears, please enter the
default password "admin" and press Login to enter the main screen of Switch. The login screen in Figure 3-20 appears.
17