Planet GSW-1600S User Manual page 24

3.1.2.5 Trunking
This function provides to cascade two Switch devices with a double bandwidth (maximum up to 1.6/2.4Gbps in full duplex
mode). There are three selections in each trunk group setting as follow:
Group 1: Selection 1(Disable)
Selection 2(port 1, 2)
Selection 3(port 1, 2, 3, 4) (GSW-1600S/2400S)
Group 2: Selection 1(Disable),
Selection 2(port5, 6),
Selection 3(port 5, 6, 7, 8) (GSW-1600S/2400S)
Group 3: Selection 1(Disable),
Selection 2(port17, 18),
Selection 3(port 17, 18, 19, 20) (GSW-2400S only)
The trunking screen in Figure 3-26 appears.
@
: Be sure that the selected trunk port must connect to the Switch under the same VLAN group
Note
3.1.2.6 Mirror
This function provide to monitoring network traffic that forwards a copy of each incoming or outgoing packet from one port
of a network Switch to another port where the packet can be studied. It enables the manager to keep close track of switch
performance and alter it if necessary. The Mirror screen in Figure 3-27 appears. Configuring the port mirroring by assigning
a source port from which to copy all packets and a sniffer port where those packets will be sent. The selection of the sniffer
mode is as follow:
RX (receive) mode: this mode will duplicate the data which the source port received and forward to the sniffer port.
TX (transmit) mode: this mode will duplicate the data which the source port transmitted and forward to the sniffer port.
BOTH (receive and transmit) mode: this mode will duplicate the data which the source port transmitted and received and
forward to the sniffer port.
Figure 3-26 Trunking Setting page
21