Table of Contents
Advertisement
Attaching Light Kit
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
To install an accessory light kit, remove the three
screws securing the switch cup assembly to the fan,
remove the switch cup assembly, and disconnect the
connector. Remove the screw plug from the bottom of
the switch cup and install the light kit in accordance
with the light kit Owner's Manual.
Maintenance
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
WARNING
!
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
NOTE: Periodically check the tightness of the
knurled knobs securing the light kit glass in the
light kit adapter. Tighten if necessary.
WARNING: For your own safety, turn off power at fuse box or circuit breaker before trouble
!
shooting your fan.
TROUBLE
1. Fan will not start.
2. Fan sounds noisy.
3. Fan wobbles
excessively.
Trouble Shooting
PROBABLE CAUSE
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan.
3. Fan/Light Wall Control is OFF.
4. Code switches in remote control/receiver are not
set in the same position.
1. Blades not attached to fan.
2
Screws holding blades to flanges are loose.
1. Setscrew in motor coupling is loose.
2. Setscrew in hanger ball/downrod assembly is
loose.
3. Hanger bracket and/or ceiling outlet box is not
securely fastened.
4. Fan blades out of balance.
Accessories
1. Ceiling Fan Light Kits (see store or catalog).
2. Ceiling Fan/Light Controls (see store or catalog).
3. Downrod Extension Kits (see store or catalog).
!
The use of any other control not specifically
approved for this fan could result in fire, shock and
personal injury.
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
1. Check main and branch circuit fuses or circuit
breakers.
!
WARNING: Make sure main power is turned off.
2. Check line wire connections to fan
3. Turn ON Fan/Light Wall Control.
4. Check that both code switches are set in the same
positions.
1. Attach blades to fan before operating.
2. Tighten screws securely.
1. Raise motor cover and tighten setscrew securely.
2. Tighten the setscrew in the hanger ball/downrod
assembly.
3. Tighten the hanger bracket screws to the outlet box,
and/or secure outlet box.
4. Interchanging an adjacent (side-by-side) blade pair can
redistribute the weight and result in smoother operation.
Or use supplied balancing kit to balance blades.
13
WARNING
WARNING
SUGGESTED REMEDY
U.L. Model No.: CF3200
Advertisement
Table of Contents
