Using Your Ceiling Fan - Emerson CF712AB02 Owner's Manual

WARNING
!
To avoid possible fire hazard, do not exceed wattage
indicated on the fitter.
LIGHT FITTER
BOWL CAP
THREADED NIPPLE
OUTER BOWL CAP
FINIAL NUT
LIGHT SWITCH
CHAIN
Figure 16
9. Position the glass bowl over the threaded nipple
and seat bowl on bowl cap (Figure 16). Pass the
fan pull chain through the bushing in the outer bowl
cap and install the cap on the threaded nipple.
Install nut finial finger tight.
CAUTION
Be sure that the fan switch chain does not make
contact with the light bulbs. If necessary
reposition the light fitter to avoid the fan switch
chain from touching the light bulbs.
10. Install pendants onto light fixture chain and fan
switch chain using couplings provided.
NOTE: It is advisable to periodically check the
tightness of the finial.
FAN SWITCH
CHAIN
60-WATT
CANDELABRA
BASE BULBS (3)
GLASS BOWL
PENDANTS (2)

Using Your Ceiling Fan

1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Check the operation of the light by gently pulling on
the light switch pull chain.
3. Check the operation of the fan by gently pulling on
the speed control switch pull chain. The operation
sequence is as follows:
1st pull - High
2nd pull - Medium
4. Your fan is shipped from the factory with the
reversing switch positioned to circulate air
downward. If airflow is desired in opposite
direction, turn the fan off and wait for the blades to
stop turning, then slide the reversing switch to the
opposite position, and turn the fan on again. The
fan blades will turn in the opposite direction and
reverse the airflow.
REVERSING
SWITCH
LIGHT PULL
CHAIN SWITCH
9
3rd pull - Low
4th pull - OFF
SPEED CONTROL
PULL CHAIN SWITCH
ETL Model No.: CF712