Nat; Virtual Servers - Comtrend Corporation WAP-5813n User Manual

Enter appropriate information for each setting and then click Apply/Save.
ND
2 LAN INTERFACE
To configure a secondary IP address, tick the checkbox outlined (in RED) below.
IP Address: Enter the secondary IP address for the LAN port.
Subnet Mask: Enter the secondary subnet mask for the LAN port.

5.4 NAT

To display this option, NAT must be enabled in at least one PVC shown on the
Advanced Setup - WAN screen. (NAT is not an available option in Bridge mode)
5.4.1

Virtual Servers

Virtual Servers allow you to direct incoming traffic from the WAN side (identified by
Protocol and External port) to the Internal server with private IP addresses on the
LAN side. The Internal port is required only if the external port needs to be
converted to a different port number used by the server on the LAN side.
A maximum of 32 entries can be configured.
23