Chapter 3 Web User Interface; Default Settings - Comtrend Corporation WAP-5813n User Manual

Chapter 3 Web User Interface

This section describes how to access the device via the web user interface (WUI)
using an Internet browser such as Internet Explorer (version 5.0 and later).

3.1 Default Settings

The factory default settings of this device are summarized below.
• LAN IP address: 192.168.1.1
• LAN subnet mask: 255.255.255.0
• Administrative access (username: 1234 , password: 1234)
• User access (username: user, password: user)
• WAN IP address: none
• Remote WAN access:
• Remote (WAN) access (username: support, password: support)
• WLAN access: disabled
• Service Set Identifier (SSID): WLAN_67E1
This device supports the following connection types.
• PPP over Ethernet (PPPoE)
• IP over Ethernet (IPoW)
• Bridging
The following connections are configured by default.
Interface Type
eth0.3 IPoW
ppp0.6 PPPoE
Technical Note
During power on, the device initializes all settings to default values. It will then
read the configuration profile from the permanent storage section of flash memory.
The default attributes are overwritten when identical attributes with different values
are configured. The configuration profile in permanent storage can be created via
the web user interface or telnet user interface, or other management protocols.
The factory default configuration can be restored either by pushing the reset button
for more than five seconds until the power indicates LED blinking or by clicking the
Restore Default Configuration option in the Restore Settings screen.
disabled
Vlan Vlan
Tag Mux IGMP
4 3 N
1 6 N
NAT FIREWALL
Y N
Y Y
9