Scsi Cable And Terminator Requirements; Scsi Cable Length; Accessories - HP STORAGEWORKS SSL1016 Reference Manual

Installation and Configuration
The following cables are shipped with your autoloader:

SCSI Cable and Terminator Requirements

If the autoloader is the last device on the SCSI bus you must attach a terminator to
the SCSI connector on the back panel of the autoloader. There must be a
terminator on each end of the SCSI bus. Typically, the host adapter provides the
front-end termination.

SCSI Cable Length

LVD SCSI configurations have a maximum allowable bus length of 39.4 feet
(12 meters). To determine the cable length of the bus, measure the lengths of the
SCSI cables connecting each device to that bus and add those lengths together for
the total length. To that total length, add 16 inches (40.64 cm) for the internal
SCSI cable length used in the autoloader.

Accessories

The following accessories are shipped with each autoloader:
24
68-pin VHDCI connector to 68-pin VHDCI connector 3 foot (.092 meter)
cable
68-pin VHDCI connector to 68-pin VHDCI connector 6 foot (1.83 meter)
cable
68-pin VHDCI connector to 68-pin HD connector 6 foot (1.83 meter) cable
Installation poster
SCSI cable(s)
RJ-45 Ethernet cable, 10 foot (3.048 meter)
SCSI terminator
Hardware brackets and handles to rackmount the autoloader
Standalone configuration hardware
Two magazines
1 data cartridge
Power cord
Rackmount template
SSL1016 Tape Autoloader Reference Guide