HP STORAGEWORKS SSL1016 Reference Manual page 37

Figure 16: Attaching the cables
Note:
the correct orientation so that you can fit a terminator or another cable in the other port.
5. If the autoloader will be the last device on the SCSI bus, install the supplied
6. Attach the other end of the SCSI cable to the SCSI host adapter card using the
7. Power on any peripheral devices you powered off in Step 2.
Note:
autoloader.
SSL1016 Tape Autoloader Reference Guide
The connector on the end of the cable is offset. Make sure that you install it with
SCSI terminator to the remaining port that is on the DCA and then tighten the
screws.
appropriate cable.
Do not power on the host computer at this time. You must first configure the
Installation and Configuration
37