Cisco 7401ASR Installation And Configuration Manual page 73

Chapter 3 Starting and Configuring
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
When asked if you want to enter the initial configuration dialog and see the current interface summary,
Step 2
enter yes or press Return:
Would you like to enter the initial configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
In the following example, the summary shows a Cisco 7401ASR router at first-time startup; that is,
nothing is configured.
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
ATM1/0
FastEthernet2/0
Step 3 Choose which protocols to support on your interfaces. For Internet Protocol (IP)-only installations, you
can accept the default values for most of the questions. A typical configuration using IP, IPX, and
AppleTalk follows and continues through
Configuring global parameters:
Enter host name [Router]:
Step 4 Enter enable secret, enable, and virtual terminal passwords:
The enable secret password is a one-way cryptographic secret
password used instead of the enable password when it exists.
Enter enable secret: barney
The enable password is used when there is no enable secret
password and when using older software and some boot images.
Enter enable password: betty
Enter virtual terminal password: fred
The Simple Network Management Protocol (SNMP) is the most widely supported open standard for
Step 5
network management. It provides a means to access and set configuration and run-time parameters of
routers and communication servers. SNMP defines a set of functions that can be used to monitor and
control network elements.
Enter yes or press Return to accept SNMP management; enter no to refuse it:
Configure SNMP Network Management? [yes]:
Community string [public]:
Step 6 For the following queries, do not enable VINES, LAT, DECnet, CLNS, bridging, XNS, or Apollo:
Configure Vines? [no]:
Configure LAT? [no]:
Configure DECnet? [no]:
Configure CLNS? [no]:
Configure bridging? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
OL-5419-01 B0
IP-Address OK?
unassigned NO
unassigned NO
Step
Configuring a Cisco 7401ASR Router
Method Status
unset down
unset down
8:
Cisco 7401ASR Installation and Configuration Guide
Protocol
down
down
3-13