Two-Post Rack Installation - Cisco 7401ASR Installation And Configuration Manual

Installing the Router

Two-Post Rack Installation

Figure 2-6
1
2
Step 1 Make sure that the port adapter latch is in the locked position and the screw is tightened.
Step 2 Make sure the rack brakes are locked or the rack is stabilized.
Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid
any sudden twists or moves.
Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
both sides of the rack.
Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
holes on the rack or mounting strip.
Step 6 For each bracket, insert and tighten two 12-24 x 0.5-inch screws to the rack.
This completes the procedure for installing the chassis in the rack. Proceed to the
Ground Connection" section on page 2-11
Cisco 7401ASR Installation and Configuration Guide
2-10
Installing the Cisco 7401ASR Router in a Two-Post Rack
ENH ANC ED
ATM
2
Two-post or four-post rack
Screw hole for the cable-management
bracket
Chapter 2 Rack-Mounting, Tabletop Installation, and Cabling
1
3
3
Four 12-24 x 0.5-inch screws
to continue the installation.
"Attaching a Chassis
OL-5419-01 B0