Cisco 7401ASR Installation And Configuration Manual page 145

Appendix D Configuration Register Information
enable
disable
enable
enable
enable
change console baud rate? y/n
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2 - 15 = boot system
Configuration Summary:
enabled are:
load rom after netboot fails
console baud: 9600
boot: image sepcified by the boot system commands or default to: cisco2-c7400
do you wish to change the configuration? y/n
You must reset or power cycle for new config to take effect
rommon 2 >
OL-5419-01 B0
"use net in IP bcast address"? y/n
"use rom after netboot fails"? y/n
"use all zero broadcast"? y/n
"break/abort has effect"? y/n
"ignore system config info"? y/n
[0]: 2
Setting the Configuration Register While Running ROM Monitor
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
[n]:y
[n] n
Cisco 7401ASR Installation and Configuration Guide
D-7