Chapter 3 Starting And Configuring - Cisco 7401ASR Installation And Configuration Manual

Chapter 2 Rack-Mounting, Tabletop Installation, and Cabling
Insert the +V lead (2) into the plug as shown in
b.
to the plug.
Insert the –V into the plug as shown in
c.
If you have a dual DC power supply, repeat Step 4 for the second plug.
Step 5
Insert the DC plug into the DC power connector on the chassis. If you have a dual DC power supply,
Step 6
insert the second DC plug into the DC power connector.
Switch the circuit breaker to the on position.
Step 7
Note After powering off the router, wait at least 30 seconds before powering it on again.
This completes the procedure for connecting DC-input power. Your installation is complete. Proceed to
Chapter 3, "Starting and Configuring,"
OL-5419-01 B0
Figure 2-18, and tighten the screw to hold the lead
Figure 2-18, and tighten the screw to hold the lead to the plug.
to start the router and to perform a basic configuration.
Cisco 7401ASR Installation and Configuration Guide
Connecting Power
2-25