Ethernet Connection(S); Rs485 Port - Bosch Divar 700 Series Installation And Operation Manual

Divar 700 Series
Pin number
1
2
3
4
5
6
Table 4.3 Keyboard out - RJ11 socket (KBD out)
4.10

Ethernet connection(s)

The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC, IP camera, or
to a network. To connect to a network hub or switch, use a straight-through network cable. To
connect directly to a PC or IP camera, use the supplied cross-over network cable. Consult
with your local IT personnel for the specific type of cable needed. The maximum cable length
from node to node is limited to 100 meters (300 feet).
Specifications
Connection: 10/100/1000 BaseT, IEEE 802.3
Differential signal voltage: ± 2.8 V maximum, inputs have transient overvoltage protection
Ethernet port details: IEEE 802.3/802.3u - 100Base-TX/10Base-T physical layer
Auto negotiation: 10/100/1000, full/half duplex
Cable length: 100 meters (100 ohm unshielded twisted pair cable or 150 ohm shielded
twisted pair cable, category 5 or higher).
Impedance: built-in compensation for impedance matching
Indicators: ACT, 10/100/1000
Figure 4.14 Ethernet connector
Signal name
LAN_TX +
LAN_TX -
LAN_RX +
N/C
N/C
LAN_RX -
N/C
N/C
Table 4.4 LAN - RJ-45 Ethernet socket
4.11

RS485 port

Connect third-party controllable cameras to the unit for pan, tilt, and zoom control.
(The Pelco D protocol is supported with the following baud settings: 2400 baud; 1 start bit;
8 data bits; 1 stop bit; no parity.)
Bosch Security Systems
Signal
No connection
System ground
Keyboard minus line
Keyboard plus line
System ground
No connection
ETHERNET
Pin number
1
2
3
4
5
6
7
8
Installation and Operation manual
Hardware setup | en
Description
Ethernet transmit line plus
Ethernet transmit line minus
Ethernet receive line plus
No connection
No connection
Ethernet receive line minus
No connection
No connection
F.01U.246.471 | v3.4 | 2011.06
31