Bosch Divar 700 Series Installation And Operation Manual page 25

Divar 700 Series
Placing a hard disk
Figure 4.4 Placing a hard disk
1.
2.
3.
4.
5.
6.
Remounting the front panel
1.
2.
3.
The location of the hard disks is not important; the unit can determine in which bay they are
installed. When installing hard disks that have recordings from another unit, the recorder
detects this and puts these drives in read-only mode.
Refer to Section 6.10 Storage, page 95 for the correct configuration procedure.
Bosch Security Systems
Locate the first empty hard disk bay. It is recommended to install the disks in order from
one to four, as labeled. (Note that disks 3 and 4 are mounted in a double bay.)
Unscrew the two torx T10 screws securing the selected bay. Slide the bay from the unit
by pulling it forward.
To replace an installed hard disk, remove the four installation screws, two per side, from
the sides of the bay. Remove the hard disk.
Mount the new hard disk into the bay with four screws, two per side (refer to the hard
disk documentation).
Align and slide the bay back fully into its slot in the unit.
Secure the bay using the two torx T10 screws removed earlier (step 2).
Repeat steps 1-5 for any additional hard disks.
When disk installation is complete, reconnect the flat cable to the front panel, if
necessary.
Align and slide the front panel to the left until it is in place.
Refasten the two captive cross head screws to the front panel.
Installation and Operation manual
Hardware setup | en 25
F.01U.246.471 | v3.4 | 2011.06