Divar 700 Series
–
–
6.6.2
Motion detection on IP cameras
With IP cameras there are two ways of performing motion detection:
–
–
Figure 6.13 Configuration menu - Motion on IP cameras
To enable motion detection in the camera:
1.
2.
Both IVA and Motion+ events are reported to the recorder as a motion detected event. The
recorder does not record IVA metadata nor support IVA-specific events such as line crossing.
To set motion detection by DVR:
1.
2.
No detection features of the camera itself are used.
Bosch Security Systems
Noise in the camera image can create false motion events, especially when detecting
small objects. Make sure the camera has been set up correctly and enough lighting is
available for the camera to obtain a noise-free image.
Ensure that the camera is mounted so that it does not shake due to wind or other
influences.
in the camera, or
in the recorder.
Click the Change button until the Motion detection by field shows Camera.
–
Now the Divar only receives a motion detected event from the camera.
Use the camera browser interface to select the type of motion detection algorithm (IVA
or Motion+) and configure the motion detection features of the camera.
Click the Change button until the Motion detection by field shows DVR.
Use the drawing area trigger level to configure the DVR motion detection, just as
described for analog cameras.
Installation and Operation manual
Advanced configuration | en
F.01U.246.471 | v3.4 | 2011.06
81