Go-Anywhere ® Helpful Hints - Weber CHARCOAL & GOOO-ANYWHERE GRILL Owner's Manual

Charcoal & gooo-anywhere grill
Table of Contents

Advertisement

Available languages

Available languages

Go-ANYwHere
ATTAcHING THe LP cYLINDer
• Turn burner control valve clockwise to
the LOCK/OFF position. Push the
cylinder slightly into valve while turning
clockwise until a snug fit is obtained.
• Check the gas connection for leaks. Mix
a couple tablespoons of liquid detergent
with an equal amount of water. Be sure
to leave the burner control valve to the
LOCK/OFF position. Wet the
connections with the detergent solution,
turn heat control valve on and watch for
bubbles. If bubbles form or if a bubble
grows, there is a leak.
• If there is a leak, check the fitting,
make sure it is tight and recheck
the connections.
• Check for gas leaks each time you
disconnect and reconnect the gas supply.
LIGHTING YoUr GAS GrILL
• Always remove the lid before lighting
your grill.
• With Flavorizer
Bar in place, turn the
®
burner control valve to the HIGH

HeLPFUL HINTS
®
position and push the igniter button
repeatedly until a flame appears on the
burner. Check to see if both sides of the
burner are lit by looking through the
viewing hole in the Flavorizer Bar.
• Replace lid and preheat for 10 minutes.
WARNING: If the burner does not
light, turn the burner control valve to OFF
and wait five minutes to let the gas clear
before you try again or try to light with a
match.
Manual lighting - with a lit match in
one hand, turn burner control valve to the
HIGH position and place match into one
of the four holes underneath the grill.
eASY GAS GrILL cAre
Your gas grill is equipped with the
advanced Flavorizer
eliminates messy, grease-collecting lava
rocks. Gas grill care (and delicious gas
grill cooking) was never easier. Follow
these easy steps frequently:
• While lid is warm, wipe inside with paper
towels to prevent grease build-up.
System that
®
• After cooking, burn grease residue off
by turning burner control valve to HIGH
for several minutes with the lid in place.
• Do not wash cooking grate after each
use. Simply loosen residue with a brass
bristle grill brush or crumpled aluminum
foil. Then wipe with paper towels.
Thoroughly clean your gas grill at least
once a year.
IT'S EASY TO DO:
• Remove cooking grate and
Flavorizer
Bar.
®
• Remove tubular burner before cleaning
(refer to Assembly Instruction sheet).
To remove: Take out burner clip and
remove valve assembly. Remove wing
nut and lock washer (on opposite end
inside unit). Lift tubular burner up and
slide out of grill.
• Wash with a mild detergent and water.
Rinse well. Wash Flavorizer
cooking grate with warm soapy water.
Rinse, then wipe dry with a paper towel.
• Reinstall tubular burner, Flavorizer
and cooking grate.
®
Bar and
Bar,
®

Advertisement

Table of Contents
loading

Table of Contents