Figure - Boca Systems Micro Plus User Manual

MINI/MICRO?
Defines the type of printer.
MINI Is for a printer with a Silent Cutter Assembly (SC2) ( Mini, Mini Plus, Mini MB,
Dual Mini)
MICRO Is for a printer without a SC2 (Micro, Micro Plus, Micro MB, Dual Micro)
(factory default)
PRINT SPEED?
Controls the speed the ticket travels at. Also effects the print
quality.
The numbers range from 0 - FASTEST to 7 - SLOWEST. 3 is factory default.
DIAGNOSTIC MODE?
Please consult your Programming Guide
Your choices are YES or NO. NO is factory default.
TICKET TYPE?
Defines how the optos are configured on the paper guide assem-
bly.
NORMAL )
Both optos are inline with each other (usually mounted on a black bracket
(factory default)
ATM
Feed opto is mounted under the thermal head and cut opto is attached to the cutter
assembly.
LABEL
Same as ATM but the cut opto is a see through type.
SPECIAL TICKET
This option is for a Micro MB printer
STATUS ENABLED?
Enables or disables the X-ON/X-OFF and status response
protocols.
Your choices are YES (Enabled) or NO (Disabled). YES is factory default.
TRANSPARENT MODE?
Please consult your Programming Guide
Your choices are YES (Enabled) or NO (Disabled). NO is factory default.
PAPER MODE?
Is generally used only for test purposes. It may also be used on
roll stock with no black marks on the ticket.
Your choices are YES (Enabled) or NO (Disabled). NO is factory default.
INC CUT1 COUNT?
Enables the operator to move the cut or tear position to the
left (towards the ticket entrance area). Cut counts are increments of .003" for 300dpi
and .002" for 200dpi. The count value is changed by depressing CHOICES. 16 is fac-
tory default.
DEC CUT1 COUNT?
Enables the operator to move the cut or tear position to the
right (towards the ticket exit area). Cut counts are decrements of .003" for 300dpi and
.002" for 200dpi. The count value is changed by depressing CHOICES. 16 is factory
default.