Specifications - K-array Ko40 User Manual

KO70

10. SPECIFICATIONS

Speakers power
handling
Maximum power
Impedance
Frequency range 20 Hz - 150 Hz +/- 3dB (preset dependent)
SPL 1W/1mt
Maximum SPL 136 dB continuos - 140 dB peak
Type
Frequency 150 Hz maximum (preset dependent)
2 x 21" Neodymium speakers with 6"
Analog 2 male + 2 female 3-pin balanced XLR
Connectors
Connectors
Connectors
Notes for data
1. Maximum RMS applicable power for a musical signal, the reference signal is the one proposed by EIAJ
standard.
2. Measured @4 mt then scaled @1 mt
3. Amplifier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the
amplifier will produce into the nominal load impedance.
New materials and design are introduced into existing products without previous notice. Present systems
may differ in some respects from those presented in this brochure.
13
Acoustics
3000 w
(EAS)
8000 w
1
2 X 8Ω
99.5 dB
2
Coverage
omni
Crossover
DSP controlled
Transducers
voice coil
Audio Input
Remote control Input
2 x female 8 poles RJ45
Power Input
2 x PowerCon IN/OUT
KO70
Type 2 modules class D - DSP controlled
3500 watts x 2 channels on 8 ohm (7000
Power
Dynamic limiter, over current, over temp,
Protection
Operating range 115 V - 230 V, 50/60 Hz (85V – 270 V)
Max continuos
and Standard 16A(>10 sec) - 32A (<1 sec)
burst current
Dimensions
Weight
Amplifiers
watt total @8Ω
3
short circuits
AC power
(Auto Switch)
Physical
115.0 x 60.0 x 85.0 cm
(45.27" x 23.62" x 33.46")
78.0 kg (171.96 lbs)
REV. B