Related Manuals for K-array Concert Series
Summary of Contents for K-array Concert Series
- Page 1 Stacking the Concert Series Ver. 1.1 STACKING THE CONCERT SERIES RIGGING MANUAL English...
-
Page 2: Table Of Contents
Stacking the Concert Series Ver. 1.1 TABLE of CoNTENTS SYMBoLS ................3 1. INTRoDUCTIoN ..............4 2. SYSTEM CoMpoNENTS ............4 ..............4 2.1 LoUDSpEAkER ENCLoSURES ................. 5 2.3 STACkING hARDwARE 3. SAfETY INfoRMATIoN ............6 4. pRoDUCT ovERvIEw .............. 7 5. -
Page 3: Symbols
Stacking the Concert Series Ver. 1.1 SYMBoLS K-array declares that this device is in compliance with applicable CE standards and regulations. Before putting the device into operation, please observe the respective country-specific regulations! Waste Electrical and Electronic Equipment (WEEE) Please dispose of this product at the end of its operational lifetime by bringing it to your local collection point or recycling center for such equipment. -
Page 4: Introduction
This manual assumes that the owner(s) and/or user(s) of a K-array system are knowledgeable and experienced in the areas of rigging and flying loudspeaker systems. -
Page 5: Stacking Hardware
Stacking the Concert Series Ver. 1.1 2.3 STACkING hARDwARE K-HCBASE K-HCBASE2 Accessory to stack up to three KH5 or Accessory to stack up to six KH2. Please note up to four KH3 that the only difference between the K-HCBASE and the K-HCBASE2 is the diameter of the holes... -
Page 6: Safety Information
Europe. However, the user must assume responsibility for making sure that use of any K-array system and its components in any particular circumstance or venue conforms to all applicable laws and regulations in force at the time. -
Page 7: Product Overview
Stacking the Concert Series Ver. 1.1 4. pRoDUCT ovERvIEw KH5 UNIT 8,3 in 47,0 in 210 mm 1194,6 mm 49,6 in 1260 mm Weight 61.2 kg (134.9 lbs) KH3 UNIT 43,5in 1104mm 47,1in 1195,08mm Weight 46 kg (101.4 lbs) - Page 8 Stacking the Concert Series Ver. 1.1 KH2 UNIT 0,3 in 29,3 in 0,3 in 8 mm 745 mm 8 mm 30,2 in 767 mm Weight 31.2 kg (68.8 lbs) K-HCBASE/K-HCBASE2 25,7in 653,2mm 5,7in 144,4mm 5,0in 127mm 24,5in 621,5mm...
-
Page 9: Stacking A Cluster
Stacking the Concert Series Ver. 1.1 5. STACkING A CLUSTER The K-HCBASE accessory allows the stacking of up to three KH5 units and up to four KH3 units while the K-HCBASE2 allows the stacking of up to six KH2 units. - Page 10 Stacking the Concert Series Ver. 1.1 Insert the four 12x25 quick release pins supplied with the system to secure the unit to the base. Level off the base so that the KH5/KH3 is in perfect vertical position.
- Page 11 Stacking the Concert Series Ver. 1.1 To connect another unit, insert the two plates supplied with the system as shown in the picture below (the base is not shown). Plug the two 12x25 quick release pins supplied with the system in the rear holes to secure the plates...
- Page 12 Stacking the Concert Series Ver. 1.1 Insert two 12x25 quick release pins in the front holes corresponding to the angle you would like to maintain between the two units. Insert the next unit.
- Page 13 Stacking the Concert Series Ver. 1.1 Plug four 12x25 pins to secure the two units. Repeat Steps 4 through 8 to connect the next unit.
-
Page 14: Stacking A Kh2 Cluster
Stacking the Concert Series Ver. 1.1 5.2 STACkING A kh2 CLUSTER These step-by-step instructions explain how to stack a cluster composed KH2 units. Please note that you will need the K-HCBASE2 accessory to stack the cluster. The K-HCBASE2 is very similar to the K-HCBASE but features holes with a different diameter to insert smaller pins. - Page 15 Stacking the Concert Series Ver. 1.1 Insert the four 8x20 quick release pins supplied with the system to secure the unit to the base. Level off the base so that the KH2 is in perfect vertical position.
- Page 16 Stacking the Concert Series Ver. 1.1 To connect another unit, insert the two plates supplied with the system as shown in the picture below (the base is not shown). Plug the two 8x20 quick release pins supplied with the system in the rear holes to secure the plates...
- Page 17 Stacking the Concert Series Ver. 1.1 Insert two 8x20 quick release pins in the front holes corresponding to the angle you would like to maintain between the two units. Insert the next unit.
- Page 18 Stacking the Concert Series Ver. 1.1 Plug four 8x20 pins to secure the two units. Repeat Steps 4 through 8 to connect the next units.
-
Page 19: Installing On A Ks5 Subwoofer
Stacking the Concert Series Ver. 1.1 5.3 INSTALLING oN A kS5 SUBwoofER Both the K-HCBASE and the K-HCBASE2 can be installed on a KS5 subwoofer to create a compact powerful full range system. Do not ground stack a cluster on uneven ground or platform. If the system is ground stacked on a structure, platform or stage always check that it can support the total weight of the system. -
Page 20: Service
The contents of this manual are furnished for informational purposes only. K-array s.u.r.l. assumes no responsibility for any errors or inaccuracies that may appear in this manual. K-array s.u.r.l. reserves the right to make modifications without prior notice.