VKI Technologies Eccellenza Café Operating Manual page 77

d. After this stage is finished, the display will show "Press Start When
Ready". Prior to pressing Start, remove the bottles, leaving the flavor
tubes disconnected.
e. Press "Start" and three cleaning cycles will commence - the flavor
pumps will cycle for three seconds, and then pause for 15 seconds,
purging the water from the tubes.
9. Once the cycle is completed, exit the rinse cycle mode by pressing on the
"Rinse Cycle" button inside the door.
10. Install new flavor bottles onto their supports and connect the respective tubing to
each of the flavor bottles.
11. Prime each of the pumps to fill the tubes with flavoring.
12. Fill a spray bottle with the sanitizing solution (2ml sanitizer per liter of
water).
13. Remove the cup stand, the carafe tray and their grills and thoroughly spray
each of them with clean sanitizing solution. Allow them to air dry – do not
rinse and do not wipe.
14. Thoroughly spray the spout support plate and pump spouts (at the
dispensing area) with the sanitizing solution. Allow it to air dry – do not rinse
and do not wipe.
15. Thoroughly spray sanitizing solution onto the door shelf and lower wall on the
inside of the door, as well as the complete dispensing area on the outside of
the door. Allow it to air dry – do not rinse and do not wipe.
March 3, 2014
Eccellenza Café – Operating Manual
77