Oki PACEMARK 4410 Maintenance Manual page 91

Item No. Items
4 LF Motor Belt Tension
5 Slice Level Setting-Paper
Width Sensor
Position Correction - Paper
6
Front Edge Sensor
40496501TH Rev.1
Standard Value
200 ~ 250gf
Drive Pulley A
Idle Pulley Assy
Mounting Screws
LF Motor Gear
Illustration
1Adjust the LF motor belt tension, with
the idle pulley assy, to produce the
standard value when the belt is deflect-
ed 1.5 mm at the middle of the LF gear
and the drive pulley B.
Drive Pulley B
Belt
LF Gear
1Install the ribbon cassette only.
2Turn on the printer while pressing
Switches 9 and A at the operation
panel. (This starts the slice level cor-
rection mode - paper width sensor.)
Confirm "COMPLETE" is indicated on
the LCD. The cover should be closed
during this process.
Notes:
In the following cases, this adjustment
should be implemented.
1) After replaceing the Control board.
(not required after ROM replacement)
1Set the continuous form (1P, 15 in.
wide and 55 Kg) at the front tractor and
also the ribbon cassette.
2Turn on the printer while pressing
Switches 0 and C. (This starts the
paper front edge sensor position correc-
tion mode.)
Confirm paper feeding/parking has
been repeated 3 times and then "COM-
PLETE" is indicated on the LCD.
Notes:
In the following cases, this adjustment
should be implemented.
1) After replaceing the Control board.
(not required after ROM replacement)
Adjustment Method
91